Hi folks,
In order to check the tool is long enough to machine in R18, I check the tool length as the attached image. I want programmatically to implement this function (actually run it in batch mode).
1. How can I put the parameter "Offset on tool holder radius (dR)" and "Offset on tool length (dL)" as 5mm and 0mm respectively?
2. How can I get the result programmatically ? For instance, 74.967 and 74.93 shown in the attached image.
Would it be done using VBScript, VBA or CAA? Any ideas, comments will be appreciated.
Cheers,
Fish |