Home  > Collaboration > Discussion Forum > Active Discussions

Welcome to the COE Discussion Forum! 

 

To participate in the discussion forum, you must be logged in to the website.  If you forget your login information, please contact COE Headquarters at coe@coe.org or (800) 263-2255.

If you are new to the COE Discussion Forum and would like to participate, please register.
Register Today
COE 2009 Annual PLM Conference & TechniFair

COE DISCUSSION FORUM
Forums > COE Forums > CATIA V5
Subject: Detailed electrical work bench issues

You are not authorized to post a reply.   
Page 2 of 2 << < 12
Author Messages
ghartley

18 Sep 2008 12:03 AM
Does anyone have an issue with releasing Electrical data into PLM/ Teamcentre??
Basically we take the circuit info from Zuken/ CHS and import into Catia 3D model. Do the automaic wire routing and everything works fine. However when we release into PLM and then go to open the harness model from PLM all the wire information has dissapeared.
ghartley

18 Sep 2008 12:05 AM
Connector detail views in Catia V5.

Does anyone have a quick way of creating for example a rear face connector 2D detail view? We are using them for the 2D circuit design as NFIG's. However the process we are using to create them is very long winded so i was wondering if there is any easy way?

Cheers
Gregg
ghartley

18 Sep 2008 12:08 AM
Does anyone create anything within the harness 3D model to show the variation in tolerence/ movement etc etc?
If so is there any easy way of doing it other than creating surface data around the harness? Is there some sort of simulation that can be done? If so how is this done?

Thanks again for the help

Gregg
tjs4689


19 Nov 2008 02:01 PM

Do you have an example i could follow for the formula, publication and process?

I will over the hollidays put together a data pack for you to review.  Do you have access to DS to ask about your specific configuration?  Most of the time this is used for cable ties and other device that must adapt to the outside diamter of the bundle segement.  More to come...
Timothy J. Suhr
COE EME DPC Co-Chair
Technical Product Designer
The Boeing Company
Boeing - Phantom Works
Product, Process & Resource Definition (PPRD)
P.O. Box 3707 M/S 42-54
Seattle, WA 98124-2207
tjs4689


19 Nov 2008 02:05 PM
Does anyone create anything within the harness 3D model to show the variation in tolerence/ movement etc etc?
If so is there any easy way of doing it other than creating surface data around the harness? Is there some sort of simulation that can be done? If so how is this done?

Gregg,
Since V5R12 the Kinematic Simulation of Contextual Parts has been turned off. You will need to request from your DS contact an environmental variable that turn this back on.
Timothy J. Suhr
COE EME DPC Co-Chair
Technical Product Designer
The Boeing Company
Boeing - Phantom Works
Product, Process & Resource Definition (PPRD)
P.O. Box 3707 M/S 42-54
Seattle, WA 98124-2207
You are not authorized to post a reply.
Page 2 of 2 << < 12
Forums > COE Forums > CATIA V5 > Detailed electrical work bench issues


ActiveForums 3.6

    

401 North Michigan Avenue, Chicago, IL 60611-4267 | (312) 321-5153 | (800) COE-CALL (U.S.)