when I measure a distance, the display in the graphic area is not the same in the table, see the attached picture.
Is it the problem of the monitor, or other reason?
please give me a hand.
thanks.
COE Administrator
measure error
January 5, 2006 12:41 PM
(in response to Madhan D)
While I don't know the answer to your question, this problem seems
to be bigger than just this measurement.
In your screen capture, you have:
"PartBod" instead of "PartBody"
"urface.2" instead of "Surface.2"
"easure Between" instead of "Measure Between"
etc.
I can't imagine what's causing this problem.
In your screen capture, you have:
"PartBod" instead of "PartBody"
"urface.2" instead of "Surface.2"
"easure Between" instead of "Measure Between"
etc.
I can't imagine what's causing this problem.
Neville Johnson
measure error
January 5, 2006 04:51 PM
(in response to Madhan D)
The value in the table is correct although you have the mode set to
approximate which is normally used for measurements in CGR
mode.
I guess you have a problem with your graphics card not your monitor.
Do you have a certified graphics card utilising the latest drives?
I guess you have a problem with your graphics card not your monitor.
Do you have a certified graphics card utilising the latest drives?
COE Administrator
measure error
January 6, 2006 03:26 AM
(in response to Madhan D)
I had such problems several times. In one case it was model problem
and it solved by CATDUA utility.But in your case it looks like
video card problem.Try to change drivers for you card. (note that
sometimes the latest drivers not the best one )
Quang T Pham
measure error
January 6, 2006 09:45 AM
(in response to Madhan D)
Not sure what card you have, but here is a link to Dessault
certified drivers for Nvidia Quadro graphics cards.
http://www.nvidia.com/object/dassault_certified_drivers.html
http://www.nvidia.com/object/dassault_certified_drivers.html
Madhan D
measure error
January 7, 2006 04:01 AM
(in response to Madhan D)
thank you very much, i think it maybe the card's problem. I will
test it.
COE Administrator
measure error
January 9, 2006 08:04 AM
(in response to Madhan D)
Are you using a laptop with a widescreen?
If so, you can try something like this.
CATWidthMMOfScreen=340 [display width in mm]
CATHeightMMOfScreen=200 [display height in mm]
If so, you can try something like this.
CATWidthMMOfScreen=340 [display width in mm]
CATHeightMMOfScreen=200 [display height in mm]
Dave Frank
RE: measure error
August 11, 2021 04:15 PM
(in response to COE Administrator)
The Video card looks like the issue for me. A coworker was
checking thicknesses and got strange values. .500 was showing
.495-.505. I tried it on my box with a good Nvidia card, and
it showed the proper thicknesses.
Dave Frank * Dasco Engineering.
NC Programming Lead
COE Product Co-Chairman, Digital Numerical Control