PP statement does not output Double CUTCOM statement in Aptourse

Apparently CATIA won’t output 2 CUTCOMs in a row.

EXAMPL 1::::::::::::::

CATIA PP statement

STOP

INSERT(CHECK .2490 - .2505 MODIFIED CLOSE REAM)

SPINDL/ 2678.000000,CLW

COOLNT/THRU, HIGH

DELAY/2

APPLY/PRSSUR

OPSKIP/OFF

CUTCOM/ON,LENGTH,NOW

CUTCOM/ON,ADJUST

APTSOURCE DOES NOT CONTAIN SECOND CUTCOM STATEMENT (CUTCOM/ON,ADJUST)!!!!

STOP

INSERT(CHECK .2490 - .2505 MODIFIED CLOSE REAM)

SPINDL/ 2678.000000,CLW

COOLNT/THRU, HIGH

DELAY/2

APPLY/PRSSUR

OPSKIP/OFF

CUTCOM/ON,LENGTH,NOW

 SECOND EXAMPLE - SWITCHED CUTCOM STATEMENTS

CATIA PP statement

STOP

INSERT(CHECK .2490 - .2505 MODIFIED CLOSE REAM)

SPINDL/ 2678.000000,CLW

COOLNT/THRU, HIGH

DELAY/2

APPLY/PRSSUR

OPSKIP/OFF

CUTCOM/ON,ADJUST

CUTCOM/ON,LENGTH,NOW

APTSOURCE DOES NOT CONTAIN SECOND CUTCOM STATEMENT (CUTCOM/ON,LENGTH,NOW)!!!

STOP

INSERT(CHECK .2490 - .2505 MODIFIED CLOSE REAM)

SPINDL/ 2678.000000,CLW

COOLNT/THRU, HIGH

DELAY/2

APPLY/PRSSUR

OPSKIP/OFF

CUTCOM/ON,ADJUST

From what I have seen the the one PP command that CATIA pays attention to is CUTCOM.  It will only put one out at a time and not concurrently.  It also has an issue with where you output them.  I have not seen anything about this in the PP Table documentation, likely an un-documented "feature". 

Fred Nemecek

Austin N.C., Inc.

512/458-1112 x119