-

I have been working with piping and making libraries for 3 months. I have a lot of problems during modelling piplines, especially I can't find parameters which allow me to change minimum length of stright part (pipe). I'm not sure if I can model pipelines with only parts are put in PipingParts.cat or if I must put parts in PipingSpecification.cat. I can't control where the parts place on the run. I have some similer problems with HVAC.

Author: jr

Hi I have some experiece in Piping Design & creation of Catalogs and worked with EQT,PID,SFD,HVAC etc. Would beinterested Kindly give detaisl.


Please contact me at :

[login to unmask email]

VK Mishra

1. to change minimum length of stright part (pipe).
Go into the run definition, highlight one of the straight segment and right click select definition, you can input the exact segment length.

2. can't control where the parts place on the run
Can directly place the part into the * connection region.

Billy